Applications
As would be expected from such a coating system, the applications are wide and varied:
- Agitator Paddles.
- Aircraft Landing Gear.
- Aluminium can be Sprayed Very Densely.
Coatings of 7mm have been achieved and subsequently finely machined. - Ball Valves Reconditioning.
- Calendar Rolls.
- Compressor Repair.
- Corrugated Paper Rolls.
- Crankshafts Refurbishment.
- Damaged Shaft Repair.
- Francis Runners – Wear Resistant Coatings.
- Gas Turbine Compressor Seals and Automotive.
Turbochargers benefit from the application of an Aluminium/Polyester Powder Blend applied by the High Velocity Process. - Hard Chrome Plating Replacement.
For many years, hard chromium plating has been widely used in fluid handling and hydraulic applications. It has been proven to give adequate wear resistance in many cases and to provide an appropriate surface against which fluids may run. However, many situations exist where performance can be radically improved, whether in terms of pure wear or in combination with corrosion resistance. Thermally sprayed coatings are available in such a wide selection of materials and to such quality as to be able to exceed the requirements of almost any hard chrome application. The health and safety aspects of plating with hexavalent chromium have also been an increasing cause for concern. So much so, that some institutions intend to ban its use entirely. Thermally sprayed coatings do not produce effluent that is difficult to dispose of and the plant involved does not contain thousands of litres of toxic chemicals. It is also an ‘in-line’ process rather than a batch process so that material is only used or stocked during production. A further point worth noting is that the size of component for thermal spraying is not limited by the size of the otherwise plating bath. - Hard Surfacing.
- Hydraulic Cylinders.
- Incinerator Firewalls are Protected from Corrosion.
At medium temperature by coatings of Inconel 625 and super-heated tubes by Chromium Carbide in a Nickel based matrix. - Kaplan Turbine Blades.
- Mining Truck Front Strut and Wheel Spindle Reclamation.
- Other Plating Operations can also be Replaced.
Copper can be sprayed for inking rolls in the Printing Industry as well as providing excellent electrical conductivity properties for a variety of applications (for example). - Pelton Runners.
- Piston Rider Bands.
- Piston Rods.
- Pump Components.
Either as OEM or repair can be given enhanced lifetime and improved performance using a Nickel/Chrome/Iron/Molybdenum. - Pump Rotors.
- Sludge Dryer Cylinders.
- Turbine Shaft Repair.
- Valves and Pumps Subject to Erosive Wear.
From particles such as sand or ash etc can be protected using Tungsten Carbide/Cobalt/Chromium materials resistant to both wear and corrosion and in special circumstances Stellite 6 can be sprayed as a replacement of a weld clad overlay. - Wear Resistance.
As more and more Engineers become aware of availability and capability of High Velocity Systems then the applications for the process will surely grow well beyond its existing market. Our video presentation below demonstrates the Hipo Jet 2700 HVOF system coating a pipe using MSSA HV 40/60.
For more information on our equipment or consumables, call us on 07 3823 1004, or email us using our contact form.