Features

- Axial powder injection.
- Variable gun power: adding different gases, one can increase or decrease power, combustion temperature and thrust of the HVAF | HVOF gun.
- Blast and spray operation is possible.
- Works in HVOF system mode + Economy, Balanced or Ultra HVAF modes*.
- Air cooling (no need for water chiller, mobile friendly).
- Direct measurements of each gas mass flow, including compressed air used for combustion, as well as continuous measurements of the chamber pressure and the pressure of all gases entering the gun, provide information necessary for scientific developments and modeling, and for comparison to other thermal spray systems and guns.
- There is no pressure drop in the internal combustion air circuit, associated with the exhaust of cooling air connected to atmosphere. Thus, for the same inlet air pressure, the combustion chamber pressure in the C7 gun is maximized. This provides a wider technological window for the gun’s operation at an available capacity of the air compressor.
- The control of combustion air accuracy increases in the absence of the influence of the cooling air line. This provides better precision and repeatability of results for collecting scientific data.
- Independent control of the cooling air allows improving the nozzle temperature regulation.
- The system may work with two smaller air compressors, only one of which (about 1/2 of total capacity) is required to be a “dedicated air compressor.” The second air compressor can pump air for other needs – grit blasting, the operation of other thermal spray systems, etc. This approach maximizes the use of resources.
- The combined HVAF / HVOF system allows spraying both coarse and very fine particles. For the same gaseous jet, using a smaller particle size allows reaching a higher particle velocity and more accurate and uniform heating. This expands the window of parameters using existing energy resources.
- An additional option for hydrogen injection creates a tool for spray particle temperature control without a change of their velocity, as well as providing additional protection against spray material oxidation, including the prevention of the decomposition of carbides accelerated by the oxidation process. At the least, this feature allows coating developers to single out one parameter (particle temperature) in the modeling of the process.
- The inert gas injection would result in utilizing an “Oxygen-Depleted HVAF” process. Currently, this process is practically unknown in the thermal spray industry, creating an opportunity for new coating developments.
*What are Economy, Balanced, and Ultra HVAF modes of tungsten carbide coating deposition?
| Coating WC-Co-Cr 86/10/4 Spray Mode |
Coating Hardness (HV300) | Coating Porosity (%) | Deposit Efficiency |
| HVOF | 1,050 – 1,250 | <0.8 | 55 |
| HVAF Economy (E) | 1,050 – 1,250 | <0.8 | 60+ |
| HVAF Balanced (B) | 1,250 – 1,350 | <0.5 | 48 – 52 |
| HVAF Ultra (U) | 1,350 – 1,600+ | <0.3 | 36 – 42 |
With this HVOF system, we are not limited to the “best coating possible.”
We can choose how to spray carbide coatings:
- Spray in HVOF mode with HVOF sized materials to get the usual HVOF coating quality with 60% cost.
- Save money in HVAF economy mode, getting the same quality as HVOF with higher deposition efficiency and twice lower costs.
- Apply the highest coating quality with HVAF U-mode to get high-hardness, ductile, non-porous abrasion and cavitation resistant coatings.
- Or choose HVAF Balanced mode to gain a competitive edge in both cost and quality.
A Variety of Hardware Setups for Different Powder Materials and Different Process Requirements
The C7 HVAF | HVOF gun has many developed nozzle setups, including under-expanded, calculated (Laval) and over-expanded nozzles, two possible powder injectors and several types of combustion chambers.